Filter
Top Products
4.
Use the dial and cursor [
Q
]/[
W
] keys to specify the
copy-source track and V-take.
In "TR xx-yy," "xx" is the copy-source track number, and
"yy" is the V-take number. Use the dial to select the track
number (1 – 10), and use the cursor [
Q
]/[
W
] keys to select
the V-take number (1 – 10).
If you turn the dial toward the right when track 10 is
selected, the following screen will appear.
In this screen you can use the dial to specify two adjacent
odd-numbered/even-numbered tracks (1/2, 3/4, 5/6, 7/8,
9/10) as the copy-source. In this case, the V-takes currently
selected for the two selected tracks will automatically be
selected as the copy-source.
5.
Press the [ENTER] key.
A screen will appear in which you can specify the
beginning of the copy-source.
6.
Use the cursor [
E
]/[
R
] keys to move the blinking
area in the display, and turn the dial to specify the
location.
The location can be specified in one of the following two ways.
• Specifying the location numerically
Move the blinking area to one of the M (minutes) / S
(seconds) / MS (millisecond) areas in the bottom of the
display, and turn the dial to edit the value of each unit.
• Assigning a previously-specified mark location
Move the blinking area to the MARKER area in the upper right
of the display, and turn the dial to specify the mark number.
• By pressing the [TIME BASE] key to switch to the
Measure display, you can specify the location in
measure/beat/clock units.
• By holding down STOP[
P] and pressing the PLAY[R]
key, you can scrub-play the track and V-take you
specified in step 4. For details on using scrub-playback,
refer to p.31.
• The starting location can be specified only between the
beginning of the song and the last-recorded location (i.e.,
within the recorded data).
7.
When you have finished specifying the starting
location, press the [ENTER] key.
A screen will appear in which you can specify the ending
location of the copy-source.
8.
Specify the ending location of the copy-source in
the same way as in step 6.
At this time, you can press the PLAY[
R
] key to play back
the region between the specified starting location and
ending location. If there is no recorded data at the specified
ending location, an "*" symbol will appear in the lower line
of the screen.
9.
When you have finished specifying the ending
location, press the [ENTER] key.
A screen will appear in which you can specify the copy-
destination track (and V-take).
10.
Specify the copy-destination track and V-take in
the same way as in step 4.
A screen will appear in which you can specify the copy-
destination location.
11.
Specify the copy-destination location in the same
way as in step 6, and press the [ENTER] key.
A screen will appear in which you can specify the number
of times (1 – 100) that the data will be copied.
HINT
ZOOM MRS-1044
39
Reference [Recorder]
Track editing