Filter
Top Products
Here's how to edit the effect type and effect parameters for
the currently selected patch.
1.
Press the [EFFECT] key to make the key light.
The display will indicate the currently selected patch.
2.
Use the ALGORITHM keys to select an algorithm,
and turn the dial to select the patch that you want
to edit.
It is not possible to change the algorithm of the currently
selected patch. For this reason, you must first begin by
selecting a patch that uses the desired algorithm, even
when you want to create a patch from scratch.
3.
Press the [EDIT] key.
The upper part of the display will indicate "EDIT." This
means that the patch may now be edited.
4.
From the MODULE keys, press the key for the
effect module that you want to edit.
When editing a patch, use the MODULE keys to select the
module for editing. The table below shows how the
MODULE keys correspond to the various effect modules.
The following display is an example of when the
[MODULATION/DELAY] key is pressed to select the
MODULATION/DELAY effect module.
If you select an effect module using a key other than the
[TOTAL] key, you can use the cursor [
Q
]/[
W
] keys to
access the setting screens for the effect type and effect
parameters of that module.
• The lit/dark condition of the [COMPRESSOR], [PRE
AMP/DRIVE], [EQUALIZER], and [MODULATION/DELAY]
keys indicates the on/off status of the corresponding
module. (If you select an effect module that is off, the
display will indicate "-OFF-.") Each time you press one of
these keys, the setting will alternate on/off.
• To edit the ZNR or VOL PDL modules, press [TOTAL],
and then use the cursor [
Q]/[W] keys to display either
"ZNR" or "VOL PDL." Then turn the dial to edit the
parameter.
5.
If you want to switch the effect type for the
selected module, press the cursor [
Q
] key to make
the display show "TYPE," and then turn the dial to
select the desired effect type.
HINT
MODULATION/
DELAY
CHORUS
DEPTH
RATE
MIX
FLANGER
DEPTH
RATE
FB
PHASER
POSITION
RATE
COLOR
Effect
module
Effect type
Effect
parameters
ZOOM MRS-1044
79
Reference [Effects]
Using the insert effect
Algorithm
Key
GUITAR/BASS
LINE
MASTERING
MIC
SINGLE
DUAL
3BAND COMP/
LO-FI
NORMALIZE EQ ZNR VOL PDL
DIMENSION/
RESONANCE
COMP
PRE AMP/
DRIVE
EQ ZNR VOL PDL
MODULATION/
DELAY
COMP/LIM
MIC PRE+
DE-ESSER
EQ ZNR VOL PDL
MODULATION/
DELAY
COMP/LIM MIC PRE EQ ZNR VOL PDLDOUBLING
COMP/LIM ISOLATOR EQ ZNR VOL PDL
PAT LVL
PAT LVL
PAT LVL
PAT LVL
PAT LVLMODULATION/
[MODULE key correspondence]