Configuring and Managing Time Parameters 129
Resetting the Update
Interval to the
Default
To reset the update interval to the default value, use the following
command:
clear ntp update-interval
Enabling the NTP
Client
The NTP client is disabled by default. To enable the NTP client, use the
following command:
set ntp {enable | disable}
Displaying NTP
Information
To display NTP information, use the following command:
display ntp
Here is an example:
WX1200> display ntp
NTP client: enabled
Current update-interval: 20(secs)
Current time: Sun Feb 29 2004, 23:58:12
Timezone is set to 'PST', offset from UTC is -8:0 hours.
Summertime is enabled.
Last NTP update: Sun Feb 29 2004, 23:58:00
NTP Server Peer state Local State
---------------------------------------------------
192.168.1.5 SYSPEER SYNCED
The Timezone and Summertime fields are displayed only if you change
the timezone or enable summertime.
(For more information about the fields in the output, see the Wireless
LAN Switch and Controller Command Reference.)
