A SERVICE OF

logo

290 CHAPTER 13: CONFIGURING USER ENCRYPTION
Table 24 lists the encryption support for WPA and non-WPA clients.
Configuring WPA To configure MAP radios to support WPA:
1 Create a service profile for each SSID that will support WPA clients.
2 Enable the WPA IE in the service profile.
3 Enable the cipher suites you want to support in the service profile. (TKIP is
enabled by default.) Optionally, you also can change the countermeasures
timer value for TKIP.
4 Map the service profile to the radio profile that will control IEEE settings
for the radios.
5 Assign the radio profile to the radios and enable the radios.
If you plan to use PSK authentication, you also need to enable this
authentication method and enter an ASCII passphrase or a hexadecimal
(raw) key.
Table 24 Encryption Support for WPA and Non-WPA Clients
MSS
Encryption
Type
Client Encryption Type
WPA —
CCMP
WPA —
TKIP
WPA —
WEP40
WPA —
WEP104
Dynamic
WEP
Static
WEP
WPA —
CCMP
Supports
WPA —
TKIP
Supports
WPA —
WEP40
Supports Supports
WPA —
WEP104
Supports Supports Supports
Dynamic
WEP
Supports
Static
WEP
Supports