IP Interfaces and Services Configuration Scenario 135
IP Interfaces and
Services
Configuration
Scenario
This scenario configures IP interfaces, assigns one of the interfaces to be
the system IP address, and configures a default route, DNS parameters,
and time and date parameters.
1 Configure IP interfaces on the mgmt and roaming VLANs, and verify the
configuration changes. Type the following commands:
WX1200# set interface mgmt ip 10.10.10.10/24
success: change accepted.
WX1200# set interface roaming ip 10.20.10.10/24
success: change accepted.
WX1200# display interface
VLAN Name Address Mask Enabled State
---- --------------- --------------- --------------- ------- -----
2 default 10.10.10.10 255.255.255.0 YES Up
3 roaming 10.20.10.10 255.255.255.0 YES Up
4094 web-aaa 10.10.10.1 255.255.255.0 YES Up
The 10.10.10.1 interface in VLAN web-aaa is placed into the route table
automatically by MSS, to support WebAAA.
2 Configure the IP interface on the roaming VLAN to be the system IP
address and verify the configuration change. Type the following
commands:
WX1200# set system ip-address 10.20.10.10
success: change accepted.
WX1200# display system
===============================================================================
Product Name: WX1200
System Name: WX1200
System Countrycode: US
System Location:
System Contact:
System IP: 10.02.10.10
System idle timeout:3600
System MAC: 00:0B:0E:00:04:0C
===============================================================================
Boot Time: 2000-03-18 22:59:19
Uptime: 0 days 01:12:02
===============================================================================
Fan status: fan1 OK fan2 OK fan3 OK
Temperature: temp1 ok temp2 ok temp3 ok
PSU Status: Lower Power Supply DC ok AC ok Upper Power Supply missing
Memory: 156.08/496.04 (31%)
Total Power Over Ethernet : 105.6
===============================================================================
