Configuring Last-Resort Access 481
WEP Unicast Index: 1 WEP Multicast Index: 1
Shared Key Auth: NO
WPA and RSN enabled:
ciphers: cipher-tkip, cipher-ccmp, cipher-wep40
authentication: 802.1X
TKIP countermeasures time: 60000ms
vlan-name = guest-vlan
...
Beginning with MSS Version 5.0, the special user last-resort-ssid, where
ssid is the SSID name, is not required and is not supported. If you upgrade
a switch running an earlier version of MSS to 5.0, the last-resort-ssid
users are automatically removed from the configuration during the
upgrade.
Configuring
Last-Resort Access for
Wired Authentication
Ports
To configure a wired authentication port to allow last-resort access:
Set the fallthru authentication type on the port to last-resort.
Create a user named last-resort-wired in the switch’s local database.
The following commands configure wired authentication port 5 for
last-resort access and add the special user:
WX1200# set port type wired-auth 5 auth-fall-thru last-resort
success: change accepted.
WX1200# set user last-resort-wired attr vlan-name guest-vlan2
success: change accepted.
