642 CHAPTER A: TROUBLESHOOTING A WX SWITCH
The following command maps snoop filter snoop1 to radio 2 on MAP 3:
WX1200# set snoop map snoop1 ap 3 radio 2
success: change accepted.
Displaying the Snoop Filters Mapped to a Radio
To display the snoop filters that are mapped to a radio, use the following
command:
display snoop map filter-name
The following command shows the mapping for snoop filter snoop1:
WX1200# display snoop map snoop1
filter 'snoop1' mapping
Dap: 3 Radio: 2
Displaying the Snoop Filter Mappings for All Radios
To display all snoop filter mappings, use the following command:
WX1200# display snoop
Dap: 3 Radio: 2
snoop1
snoop2
Dap: 2 Radio: 2
snoop2
Removing Snoop Filter Mappings
To remove a snoop filter from a specific radio, use the following
command:
clear snoop map filter-name ap apnumber radio {1 | 2}
The following command removes snoop filter snoop2 from radio 2 on
MAP 3:
WX1200# clear snoop map snoop2 ap 3 radio 2
success: change accepted.
To remove all snoop filter mappings from all radios, use the following
command:
clear snoop map all
