Filter
Top Products
4-14
Cisco ONS 15501 User Guide
78-14134-02, Release 2.0
Chapter 4 Command Reference
get-snmp-mgr
get-snmp-mgr
To display the SNMP (Simple Network Management Protocol) manager entries on the system, use the
get-snmp-mgr command.
get-snmp-mgr
Syntax Description
Defaults Displays all IP values of the SNMP manager
Command Types Does not change configuration
Command Modes User password protected
Command History
Usage Guidelines Use this command to display SNMP manager configuration information for a single entry or for all
entries on the system.
Examples The following example shows how to display the values of SNMP managers.
edfa > get-snmp-mgr 10.1.2.71
A list of the SNMP manager IP addresses
===========================================
209.128.68.147
10.1.2.71
Related Commands
manager-ip Specifies the IP address of the host running the SNMP manager.
Release Modification
EDFA 1.0 This command was introduced.
Command Description
add-snmp-mgr Adds or modifies an SNMP manager entry.
del-snmp-mgr Deletes an SNMP manager entry.