Filter
Top Products
4-29
Cisco ONS 15501 User Guide
78-14134-02, Release 2.0
Chapter 4 Command Reference
ntp-ip
ntp-ip
To modify or display the IP addresses of the NTP (Network Time Protocol) server, use the ntp-ip
command.
ntp-ip [ip-addr1 [ip-addr2]]
Syntax Description
Defaults Displays the current IP addresses of the primary and secondary NTP servers.
If only one value is entered, that value is applied to the IP address of the primary NTP server.
Command Types Changes configuration
Command Modes User password protected for display; master password protected for modification.
Command History
Examples The following example shows how to modify the IP address of the primary NTP server.
edfa > ntp-ip 209.128.68.149 209.128.68.147
The following example shows how to display the current IP addresses of the primary and secondary NTP
servers.
edfa > ntp-ip
209.128.68.149, 209.128.68.147
Related Commands
ip-addr1 Specifies the IP address of the primary NTP server.
ip-addr2 Specifies the IP address of the secondary NTP server.
Release Modification
EDFA 1.0 This command was introduced.
Command Description
ntp Enables or disables the NTP for the system