Filter
Top Products
4-34
Cisco ONS 15501 User Guide
78-14134-02, Release 2.0
Chapter 4 Command Reference
ping
ping
To ping an IP address, use the ping command.
ping ip-address [count]
Syntax Description.
Defaults None
Command Types Changes configuration
Command Modes Master password protected
Command History
Usage Guidelines If no value is entered for the count, the system will default to 5. The system will accept a maximum count
of 20.
If the ping is issued from a Telnet session, control-c will stop the ping. If the ping is issued from a serial
port, control-c will not stop the ping.
Examples The following example shows how to ping an IP address.
edfa > ping 192.168.0.1
PING 192.168.0.1 (192.168.0.1): 56 data bytes
--- 192.168.0.1 ping statistics ---
5 packets transmitted, 0 packets received, 100% packet loss
ip-address Specifies the IP address of the host to ping.
count Specifies the number of ping packets to be sent.
Release Modification
EDFA 1.0 This command was introduced.