Filter
Top Products
4-46
Cisco ONS 15501 User Guide
78-14134-02, Release 2.0
Chapter 4 Command Reference
setoutsigpwrtrig
setoutsigpwrtrig
To set the output signal alarm trigger level, use the setoutsigpwrtrig command.
setoutsigpwrtrig trigger
Syntax Description
Defaults 20.00 dBm
Command Types Changes configuration
Command Modes Master password protected
Command History
Usage Guidelines The output signal alarm trigger is measured in dB. See Table 1-2 on page 1-2 for the minimum and
maximum values. If a value entered falls outside of this acceptable range, the command will be ignored
and have no effect.
Examples The following example shows how to set the output signal alarm trigger level.
edfa > setoutsigpwrtrig 18.00
Related Commands
trigger Specifies the desired output signal alarm trigger level.
Release Modification
EDFA 1.0 This command was introduced.
Command Description
outsigpwr Displays the calculated output signal power.
outsigpwrmean Displays the output signal alarm mean level.
outsigpwrtrig Displays the output signal alarm trigger level.
resetmeantrig Resets the signal gain and alarm mean level, gain alarm trigger level, optical
input alarm mean level, optical input alarm trigger level, output signal alarm
mean level, output signal alarm trigger level, internal case temperature
alarm mean level, and internal case temperature alarm trigger level to the
manufacturer’s default settings.
setoutsigpwrmean Sets the output signal alarm mean level.