Filter
Top Products
25
Getting ready to use the R-4
Types of batteries you can use
• AA alkaline batteries (LR6)
• AA nickel metal-hydride (HR15/51)
(The R-4 cannot recharge nickel metal-hydride batteries. You’ll need to use a separate charger.)
* You must set the R-4’s
System Settings menu
item
“5 System Setup”
(p. 63) to specify the type of batteries
you’ve installed. The R-4 will not operate correctly if you’ve specified a battery type that does not match the batteries
you’ve actually installed.
1
Make sure that the R-4 is turned off, and disconnect the AC adaptor from the AC adaptor jack.
2
Detach the battery cover from the bottom panel of the R-4.
* When turning the unit upside-down, handle with care to avoid
dropping it, or allowing it to fall or tip over.
3
Insert eight AA batteries into the battery compartment,
making sure to observe the correct polarity (+ and -
symbols).
4
Replace the battery cover.
5
Turn on the R-4.
6
Press the
[SYSTEM] button
.
7
Use the
[CURSOR] up/down buttons
to select
5 System Setup
.
8
Press the
[ENTER] button
.
9
Using the
[SCRUB/VALUE] dial
, set the
Battery Type
to
Alkaline
if you’ve installed alkaline batteries,
or to
Ni-MH
if you’ve installed nickel metal-hydride batteries. The setting is activated as soon as you
select it.
10
When you’ve finished making settings, press the
[EXIT] button
.You’re returned to the previous screen.
11
When you’re back in the
System Menu
screen, press the
[EXIT] button
once again.
Although the indication
[ENTER]
will be blinking in the display, if you don’t need to make additional
settings, press the
[EXIT] button
to return to the main screen.
Installing batteries and turning the power on
Caution when using the R-4 on battery power
• If you operate on battery power for an extended time, the batteries will become hot. Be careful not to
burn yourself.
• We recommend that you use alkaline batteries, which have a longer life.
• Don’t mix new batteries with used batteries, and don’t mix batteries of differing types.
• If you won’t be using the R-4 for an extended time, we recommend that you remove the batteries to
prevent leakage or other accidents.
• When using a USB cable to connect the R-4 to your computer, you must use the AC adaptor to prevent
the loss of power while the connection is active.
R-4_e.book 25 ページ ２００５年２月１０日 木曜日 午後３時３６分