Filter
Top Products
48
Editing
Projects you record using the R-4 can be edited directly on the R-4.
* Executing any of these editing commands will leave the original project file unchanged.
* There is no Undo function.
This command extracts the region between the two points you specify in the waveform, and creates a new
project using this extracted region.
You can perform playback, stop, or operate the scrub dial and shuttle dial even while using this command.
However, you cannot perform A-B Repeat or marker-related operations.
fig.wave-1.eps
1
Press the R-4’s
[WAVE EDIT] button
. The Wave Edit Menu
screen appears in the display.
2
Use the
[CURSOR] buttons
to choose
1 Trim
, and press the
[ENTER] button
.
fig.wave-2.eps
The editing screen shown at the right will appear.
Time axis zoom (1/1–1/65536)
Use the
[CURSOR] left/right buttons to
adjust this
Waveform level zoom (x1–x64)
Use the
[CURSOR] up/down buttons
to adjust this
* If you decide not to adjust the settings, press the
[EXIT] button
.
fig.wave-3.eps
3
While playing or fast-forwarding, press the
[ENTER] button
when you reach the beginning (point ) of the region you want
to extract.
Alternatively, you can use the scrub dial or shuttle dial to specify
the point instead of doing so during playback.
fig.wave-trim1.eps
* The value of point [ ] is shown in terms of samples (data).
No.
Editing
command
Result See
1 Trim
Specify two points in the waveform, extract the region, and create a new
project using that region.
p. 48
2 Divide
Specify one point in the waveform, and divide the project at that point.
Two new projects will be created.
p. 50
3 Combine
Append another project following the end of the currently selected
project. The two files will be joined to create a single new file.
p. 52
4
Merge
A project consisting of multiple files will be merged into a single channel.
p. 54
Editing procedure
Trim
Waveform level
zoom
Time axis zoom
Elapsed
time
Total time
1
1
Project
1
1
R-4_e.book 48 ページ ２００５年２月１０日 木曜日 午後３時３６分