Filter
Top Products
54
Editing
If the currently selected project consists of multiple files (MONO x2, MONO x3, MONO x4, STEREO x2),
this command merges them into a single channel.
How Rec Mode will change
* Since MONO x1, STEREO x1, or 4 ch. projects cannot be merged, the Merge command will not appear in the menu
if you’ve selected this type of project.
fig.merge-1.eps
1
Press the R-4’s
[WAVE EDIT] button
. The Wave Edit Menu
screen will appear.
2
Use the
[CURSOR] buttons
to choose 4 Merge, and press the
[ENTER] button
.
fig.merge-2.eps
The editing screen shown at right will appear.
If you want to adjust the level (Mix Level) of the channels in the
project, you can do so. Use the
[CURSOR] up/down buttons
or
the
[SCRUB] dial
to specify the value.
For example, in a stereo two-channel project (STEREO x2), you
might set the Mix Level to -6.0 dB so that the level of each channel
will be lowered by 6 dB when they are merged.
* If you decide to cancel, press the
[EXIT] button
.
fig.merge-3.eps
3
To execute, press the
[ENTER] button
.
If you decide not to use the Merge command, press the
[EXIT]
button
.
Even when the screen shown at the right is displayed, you can halt
execution by pressing the
[EXIT] button
.
* Don’t turn off the power while a project is being saved or while
processing is being performed.
* It may take some time to save the project if it contains a large amount of data.
Merge
Before Merge After Merge
MONOx2
MONOx3
MONOx4
MONOx1
STEREOx2 STREOx1
fig.media-full.eps
If the internal hard disk does not have enough space to save the project, a
message of “Media Full!” will appear.
R-4_e.book 54 ページ ２００５年２月１０日 木曜日 午後３時３６分