Filter
Top Products
74
Appendix
You can connect the R-4’s L connector to a video device that has a LANC connector, and make the R-4
operate in synchronization with the video device.
* The R-4 does not record or synchronize to time code. Also, the recording time on the video device and the recording
time on the R-4 may drift during long recordings.
fig.recording-1.eps
1
Press the R-4’s
[SYSTEM] button
.
The System Menu screen appears.
fig.system-1.eps
2
Use the
[CURSOR] buttons
to choose
5 System Setup
, and
press the
[ENTER] button
.
fig.system-2.eps
3
The
System Setup
screen appears.
Use the
[CURSOR] buttons
to choose
L-Connector
.
4
Use the
[SCRUB/VALUE] dial
to select Enable.
The setting is applied when you select it. You don’t need to press
the
[ENTER] button
.
5
Press the
[EXIT] button
.
You’re returned to the System Menu screen. Press the
[EXIT] button
once again to return to the main
screen.
In this state, the R-4 will operate in synchronization with your video device. For details on settings and
operation for your video device, refer to the manual of your video device.
1
Use the special cable to connect the LANC connector of your video device to the R-4’s
[L-CONNECTOR]
.
2
Power up your video device.
3
When your video device enters recording-standby mode, the R-4 will also enter recording-standby mode.
4
When you begin (or stop) recording on your video device, the R-4 will also begin (or stop) recording.
Connecting a video device that has a LANC connector
LANC connection settings
Using the LANC connection
R-4_e.book 74 ページ ２００５年２月１０日 木曜日 午後３時３６分