Filter
Top Products
58
Effects setting
You can adjust the R-4’s effects not only while standing-by for recording or playback, but also while you
listen to the sound during actual playback or recording.
This section explains how to adjust the effect settings while playing back or in recording-standby mode.
fig.effect-set.eps
fig.effect-1.eps
1
Press the R-4’s
[EFFECTS] button
.
The effect setting screen will appear in the display.
fig.effect-type.eps
2
Use the
[SCRUB/VALUE] dial
to select the desired effect type.
For details on each effect type, refer to
“Effects”
(p. 56).
fig.effect-link.eps
3
Press the
[CURSOR] down button
. The cursor will move to the
“Link” setting.
Using effects
CH1 CH2 CH3 CH4
The effect on/off setting and effect parameter settings will be independent for
each channel.
CH1+2 CH3+4
The effect on/off setting and effect parameter settings will be linked for chan-
nels 1 and 2, and for channels 3 and 4.
Choose this setting if the project uses channels 1 and 2 and channels 3 and 4
as stereo pairs.
CH1+2+3+4
The effect on/off setting and effect parameter settings will be linked for all
channels.
3
6
2
1
R-4_e.book 58 ページ ２００５年２月１０日 木曜日 午後３時３６分