Filter
Top Products
82
Troubleshooting
No sound
If the monitor level knob is turned too far down, the volume may be too low for you to hear. Gradually raise
the monitor level knob.
Refer to:
“Monitor level knob [MONITOR]”
(p. 13)
Make sure that your headphones or speakers are connected correctly.
No sound from the internal speakers
In the system settings for Speaker, make sure that Speaker Switch is ON. No sound is output from the
internal speakers if this setting is OFF.
No sound is output from the internal speakers if headphones are connected.
To prevent acoustic feedback, no sound is output from the internal speakers during recording or recording-
standby.
The CompactFlash card contains a file, but the R-4 won’t play it
The R-4 can’t directly play files from the CompactFlash card.
In order to play a file located on the CompactFlash card, use the Finder screen to copy the file onto the R-
4’s hard disk, and then play it.
Refer to: “Copying a project (Copy)”
(p. 44)
A skip of several seconds occurs in the project playback
If the R-4 is subjected to vibration or impact, writing to the hard disk may not occur in time, meaning that
that portion of sound will not be recorded. When you listen to the recorded project, the time count during
playback will not skip, but there will be a skip of several seconds in the sound of the project.
During recording, please be careful that the R-4 is not subjected to impact.
The sound skips when you play back through the internal speakers
Vibration produced by the internal speakers may cause reading from the hard disk to fail, and this may
cause skips in the sound.
Try turning the monitor level knob toward the left to lower the volume of the internal speakers.
Alternatively, you can monitor through headphones.
Skips occur in the sound
As you repeatedly write and delete project files, the files on the hard disk will become fragmented, and this
will slow down the processing speed. If you continue recording in this state, a message of “HDD Slow!”
will appear, and skips may occur in the recorded project.
If you are making important recordings, you should consistently delete all projects together when you’re
finished with them. Repeated deletion of smaller pieces of data will cause the disk to become fragmented,
possibly causing recording to fail.
Playback-related problems
R-4_e.book 82 ページ ２００５年２月１０日 木曜日 午後３時３６分