Filter
Top Products
213
Various Other Settings
Various Other Settings
This setting allows you to choose the maximum amount of Pitch
change (range) permissible when using Pitch Bend. The range
can be set anywhere between 1–12 (in semitone units; with a
maximum of one octave).
1.
Touch <Sound/KBD> on the Main screen.
The Sound/Keyboard screen appears.
2.
Touch <Controller>.
The Controller screen appears.
3.
Touch < >< > to display the Pitch Bend
Range.
fig.09-14.eps
4.
Touch the Pitch Bend Range setting.
fig.09-15.eps
5.
Touch < >< > to change the setting.
6.
Touch <Exit>.
Drums/SFX is fixed at one octave range, regardless of this
setting.
You can adjust the sensitivity of the D Beam controller.
Increasing this setting will make the D Beam controller more
responsive.
The sensitivity of the D Beam controller can vary depending on
the brightness of the surroundings. If it does not operate as
you expect, please readjust the sensitivity.
1.
Touch <Sound/KBD> on the Main screen.
The Sound/Keyboard screen appears.
2.
Touch <Controller>.
The Controller screen appears.
3.
Touch < >< > to display the D Beam
Sensitivity.
fig.09-14.eps
4.
Touch the D Beam Sensitivity setting.
fig.09-15.eps
5.
Touch < >< > to change the setting.
6.
Touch <Exit>.
This setting remains stored in memory even while power is
turned off.
Changing the Pitch Bend Range
Setting
1–12 (semitone steps)
NOTE
Adjusting the Sensitivity of the D Beam
Controller
Setting
1–10
AT-900_e.book 213 ページ ２００７年９月７日 金曜日 午前８時４３分