Filter
Top Products
226
Various Other Settings
In some cases, when USB memory is connected to the external
memory connector, it may take longer for data to be loaded,
or data may fail to be loaded successfully. If this occurs, you
may be able to solve the problem by changing the external
memory setting.
1.
Touch <System> on the Main screen.
The System screen appears.
2.
Touch < >< > to display the Ext Memory
Mode.
fig.09-44.eps
3.
Touch the Ext Memory Mode setting to switch
between “Mode 1” and “Mode 2.”
Each time you touch the Ext Memory Mode setting, it will
alternate between “Mode 1” and “Mode 2.”
4.
Touch <Exit>.
5.
Turn on the power once again.
You can turn the Remote function on (enabled) or off
(disabled).
1.
Touch <System> on the Main screen.
The System screen appears.
2.
Touch < >< > to display the Remote
Control.
fig.10-12.eps
3.
Touch the Remote Control setting to switch
between “ON” and “OFF.”
Each time you touch the Remote Control setting, it will
alternate between “ON” and “OFF.”
4.
Touch <Exit>.
This setting remains stored in memory even while power is
turned off.
Changing the External Memory Setting
Setting
MODE 1, MODE 2
Turning the Remote Function On/Off
Setting
Descriptions
ON
The remote control unit will operate the
ATELIER.
OFF
The remote control unit will be disabled.
You will not be able to operate the
ATELIER using the remote control.
AT-900_e.book 226 ページ ２００７年９月７日 金曜日 午前８時４３分