Filter
Top Products
23
Before You Start Playing
Before You Start Playing
If you feel that the ATELIER has become unstable, for example
after moving it to another location, turn the adjuster located on
the bottom of the stand’s legs as shown in the following.
• Rotate the adjustor to lower it so that it is in firm contact
with the floor. Make adjustments so that there is no gap
between the adjuster and the floor. In particular, when
placing the ATELIER on carpet, turn the adjuster so that it
is firmly in contact with the floor.
The legs of the AT-900’s bench also have adjusters. If the
bench is unstable, you can adjust its adjusters.
When turning the adjuster, be careful not to pinch your
hand.
1.
First, make sure that the [Power On] switch at
the panel’s left side is OFF (not pushed in).
fig. 00-27.eps,fig.00-27-2.eps
2.
Connect the supplied power cord to the AC
Inlet connector, then plug the other end into an
AC outlet.
Only use the power cord supplied with this instrument.
Whenever you do not intend to use the instrument for
extended periods of time, pull out the power cord from the
AC outlet.
About the Adjuster (AT-900)
NOTE
NOTE
Connecting the Power Cord
OFF
Upper position
Power Cord
AC Outlet
AT-900
Power Cord
AC Outlet
AT-900C
NOTE
NOTE
AT-900_e.book 23 ページ ２００７年９月７日 金曜日 午前８時４３分