Filter
Top Products
100
MIDI FUNCTIONS
When the operation is completed, the following display briefly ap-
pears (before returning to the original operation).
The most common use for the Initial Setup Send function is in recording a
song on a sequencer that is intended for playback with the DJX. Essentially,
this takes a “snapshot” of the DJX settings and sends that data to the
sequencer. By recording this “snapshot” at the start of the song (before
any actual performance data), you can instantly restore the necessary
settings on the DJX. Provided there is a pause in the song, you could also
do this in the middle of a song — for example, completely changing the
DJX settings for the next section of the song.
Sending Initial Setup Data
1 First, set up the sequencer for recording.
The actual procedure may differ depending on your particular equip-
ment and software.
Ideally, you should leave two or more measures of silence (no perfor-
mance data) before the song begins. The Initial Setup data should
then be recorded to this space in the song.
2 On the DJX, select the Initial Setup Send func-
tion.
Do this in the normal way:
1) Press the FUNCTION button.
2) Select parameter #87 (with the numeric keypad).
STYLE
YES
FUNCTION
End
STYLE
F87
FUNCTION
InitSend
USING INITIAL SETUP SEND WITH A SEQUENCER
USING INITIAL SETUP SEND WITH A SEQUENCER
The Initial Setup Send
function cannot be used in
the following conditions:
• While playing a pattern
• In the Song mode
• In one of the Recording
modes
• While receiving bulk/
sampling data
If you attempt the function
while in one of the above
conditions, “- - -” appears
in the display and the data
is not transmitted.