Filter
Top Products
16
Names and Functions
AUX RTN 2
R
MONO/L
AUX RTN 1
R
MONO/L
2 AUX SEND 1
RECORDER IN
R
L
MIDI
OUT
MIDI
IN
PUNCH
IN/OUT
Pin 1: GND
Pin 2: HOT
Pin 3: COLD
Refer to page 45 for more information on using the PUNCH
IN/OUT jack.
10. Punch in/out jack [PUNCH IN/OUT]
(Connector: phone)
Using an optional foot switch connected to this jack enables
you to perform the Manual Punch In/Out operation
(including rehearsal) using your foot. Connect an optional
Fostex foot switch, Model 8051.
Refer to page 77 for more information on using the MIDI IN
jack.
9. MIDI IN jack [MIDI IN] (Connector: DIN 5-pin)
Connect this jack to the MIDI IN jack of an external MIDI
device. You can control the FD-8 remotely by inputting
MMC (MIDI Machine Control) command or FEX (Fostex
System Exclusive Message) here.
Refer to page 77 for more information on the example of using
the MIDI OUT jack.
8. MIDI OUT jack [MIDI OUT] (Connector: DIN 5-pin)
Connect this jack to the MIDI OUT jack of an external MIDI
device.
This jack transmits MTC (MIDI timecode), MIDI clock & Song
Position Pointer, MMC (MIDI Machine Control) command,
response, and FEX (Fostex System Exclusive Message)
response.
Refer to page 54 for more information on using the
RECORDER IN jacks.
7. Recorder in jacks L, R [RECORDER IN L, R]
(Connector: RCA pin)
These jacks are used to route analog signals input from an
external device directly to the recorder section. Using these
jacks enables you to use only the recorder section, bypassing
the mixer section.
Signals input from these jacks are recorded to the tracks
selected by the RECORD TRACK select keys.
3. AUX Send jacks 1, 2 [AUX SEND 1, 2]
(Connector: phone)
Connect these jacks to the input of an effect unit.
The AUX SEND jacks send out signals selected and adjusted
by the AUX send knobs to the connected effect unit.
4. AUX Return jacks 1, 2 [AUX RTN 1, 2]
(Connector: phone)
Connect these jacks to the output of an effect unit.
You can also use these jacks as auxiliary inputs.
If a connected effect unit has a mono output, connect the
output to the L/MONO jack of the FD-8. The right channel
will also receive the same signal. Adjust the level of processed
signals using AUX RTN knobs 1 and 2.
5. Insert jacks 7, 8 [INSERT 7, 8]
(Connector: stereo TRS phone)
Use these jacks when you wish to apply an effect to the
signal input at input jacks 7 and 8 (unbalanced inputs on
the front panel or balanced inputs on the rear panel).
In particular, use them when you wish to apply a
compressor/limiter.
Refer to page 38 for more information on examples of using
the INSERT jacks.
6. Balanced input connectors 7, 8 [INPUT 7, 8]
(Connector: balanced XLR)
Connect sound sources that have balanced outputs, such
as musical instruments and microphones.
Input channels 7 and 8 also support phone jacks on the
front panel.
The phone jacks for input channels 7 and 8 on the front
panel have priority. If you connect sound sources to these
jacks, the balanced XLR jacks for input channels 7 and 8 on
the rear panel will be disabled.
8
7
21
INPUT 7INPUT 8