Filter
Top Products
95
Saving and Loading Song Data
POWER
R MON OUT L
R ST OUT L
AUX RTN 2
R MONO/L2 AUX SEND 1
SCSI
OUT
IN
DATA PUNCH
IN/OUT
DATA
AUX RTN 1
R MONO/L
8 INSERT 7
INPUT 8 INPUT 7
R
RECORDER IN
L
IN
MIDI
OUT
MIDI
SCSI backup drive
(ID# = 6)
Load
Save
FD-8 with a 2.5-inch internal hard disk
When the load operation is completed, [COMPLETED !]
lights up. The FD-8 displays the top of the Program in the
current drive and stops.
11. Stop playing the DAT (or adat).
12. Press the EXIT/NO key or the STOP button.
[COMPLETED !] disappears.
Saving and loading song data via a SCSI drive
This section explains how to save and load data to and from a SCSI backup drive and a 2.5-inch internal hard
disk. Recording mode on the current drive does not affect this operation. Refer to the “Saving and loading song
data between two SCSI drives” for more information on the procedure.
<Tips>
You can monitor the signal being loaded. Follow the steps below.
* Set the SELECTOR in the monitor section to “MON.”
* Turn the MON knobs for channels 1 and 2 for DAT backup (or
channels 1–8 for adat backup) toward “TRK.”
* Turn up the MASTER knob in the monitor section.
Connect a SCSI backup drive (ID #=6) to the SCSI connector on the 2.5-inch hard disk in the FD-8, as shown below.
<Note on connections>
Be sure to connect a SCSI backup drive to the SCSI connector. Make sure that the ID number for the SCSI backup
drive is set to “6.”
SCSI
OUT
IN
DATA PUNCH
IN/OUT
DATA
MONO/L
8 INSERT 7
INPUT 8 INPUT 7
R
RECORDER IN
L
IN
MIDI
OUT
MIDI
Note:
As shown in the drawing, when the SCSI drive assigned for the current drive is daisy chained to the SCSI drive for
backup and also connected to the optional 2.5 inch IDE internal hard disk which is in the current drive mode, please note the
following items.
When the 2.5 inch hard disk is assigned as the current drive:
Switch on power to FD-8 only and not to the two SCSI drives connected.
If save/load of song data is to be executed using the SCSI drive assigned for backup, switch on power to the FD-8 and the
SCSI drive assigned for backup. Do not switch on power to the SCSI drive assigned for the current drive. By utilizing either
method, FD-8 will always recognaize the 2.5 inch IDE hard disk as the current drive.
In order to use the SCSI drive as the current drive, power to any equipment that is interconnected must, of course, be
switched on. The SCSI drive will automatically switch to the current drive mode.
Backup SCSI drive
Current SCSI drive
FD-8 with a 2.5 inch internal hard disk