Filter
Top Products
Locate Function
72
RTN
AUTO
3
1
Executing the Auto Return function
1. Store the AUTO RTN START and AUTO RTN END
points.
Refer to the chapter “Storing a Locate Point (Edit Point)”
on page 66 for information on storing the desired points
in the AUTO RTN START key and the AUTO RTN END
key.
2. Press the AUTO RTN/AUTO PLAY key to turn on
the [RTN] indicator at the bottom of the display.
3. Start playback a little before the AUTO RTN END
point.
The FD-8 operates as shown in the diagram.
• You can set a preroll time in the [Preroll ?] menu in SETUP
mode so that the FD-8 will start playback preroll time before
the locate point. You can set the preroll time from 0 to 10
seconds. Refer to the chapter “Changing the Initial Settings
(SETUP Mode)” on page 102.
Auto Repeat
The Auto Repeat function allows the FD-8 to repeat playback up to the AUTO RTN END point, automatically
locate the AUTO RTN START point, then play up to the AUTO RTN END point until you cancel the function by
pressing the STOP button. To enable this function, both AUTO PLAY mode and AUTO RTN mode should be
turned on, and the AUTO RTN START point and the AUTO RTN END point should already be set.
Using this function will facilitate the Auto Punch In/Out and Manual Punch In/Out rehearsal. See “Hint”
after the following section.
<Operation of the Auto Repeat mode.>
AUTO RTN END point
AUTO RTN START point
LOCATE
PLAYBACK
START
PLAYBACK
2