Filter
Top Products
Storing a Locate Point (Edit Point)
69
4
22
1
2
3
1. While the FD-8 is stopped, press the memory key
that stores the data you wish to edit.
The stored data appears on the display and the FD-8
enters data edit mode.
2. Press the HOLD/> key, REWIND button, or the
F FWD button to move the flashing cursor to the
time value digit, and use the JOG dial to increase
or decrease the value.
3. Press the STORE key.
The STORE LED lights up.
4. Press the memory key that you pressed in Step 1
again.
The STORE LED will turn off. The edited data is stored,
and the FD-8 displays the previous Time Base indication.
Editing the data stored in the LOCATE key
You can recall the last located point and edit the value. You can use the edited value to locate the point later or
store it to another memory key.
• You can store the edited data in a memory key other than the
one you pressed when you recalled the data.
For example, you can recall the AUTO PUNCH IN point data,
edit it, and store it to the AUTO PUNCH OUT key.
• Refer to page 41 for more information on Auto Punch In/Out.
• Refer to pages 56 and 59 for more information on Copy &
Paste, Move & Paste, and Erase.
• Refer to page 70 for more information on Auto Return and
Auto Repeat.
• You can also use the Preview function to edit the stored locate
points (edit points). Refer to “Preview Function” on page 74 for
more information.
1. Press the SHIFT and LOCATE keys simultaneously
while the FD-8 is stopped.
The last located point stored in the LOCATE key appears
on the display and the FD-8 enters data edit mode.
If no data is stored (that is, if the FD-8 has not located
any point since the power was turned on), 00H 00M 00S
00F 00SF appears and “00” of the digits “00S” flashes.
2. Press the HOLD/> key, REWIND button, or the
F FWD button to move the flashing cursor to the
time value digit, and use the JOG dial to increase
or decrease the number to the desired value.
3. To located the edited point, press the LOCATE key.
When you execute the Locate function, the locate point is
stored as locate data in the LOCATE key.
4. To store the edited data to another memory key,
input the desired value, press the STORE key, then
press the desired memory key.
The data is stored to the corresponding memory key.
The data stored in the LOCATE key will not change.
Note:
You cannot preview the data stored in the LOCATE
key, unlike other memory keys.