Filter
Top Products
Editing Tracks
58
DRIVE
AUTO A.PUNCH
SYNC OUT
CLK
SCSI
?
SURE
5. Select a destination track to paste data.
All selected tracks’ LEDs light up.
You can select only mono tracks as the destination of a
copied or moved mono track. If you copied or moved
adjacent odd-even tracks, you can select only adjacent
odd-even tracks as the destination.
If you do not select any tracks, the data will be pasted
back to the copy or move source track.
6. Turn the JOG dial to enter the number of repeats
(Repeat=**).
You can enter up to 99. However, this is automatically
limited by the available recording space on the disk.
That is, if the disk has enough free space, you can set up
to 99 repeats. If the disk has only a small amount of free
space, the JOG dial allows you to set a lower number of
repeats.
7. Press the EXECUTE/YES key.
[Copy Paste] (or [Move Paste]) flashes and the duration
of the pasted data appears as a negative number on the
display. This number will count down as the paste
operation proceeds.
When the paste operation is complete, the flashing [Copy
Paste] (or [Move Paste]) lights up continuously, and
[COMPLETED !] is displayed.
Undo/Redo Paste
You can undo or redo a Copy & Paste and Move & Paste
operation.
Note:
If you try to execute the paste operation by pressing the
EXECUTE/YES key when the disk has insufficient free space, [Over
!] appears on the display and edit mode is cancelled. In this case,
you need to delete unnecessary data or Programs. Refer to the
following section, “Erase,” and to “Deleting a Program” on page 35
for more information on erasing.
8. Press the STOP button or the EXIT/NO key.
The FD-8 exits edit mode and displays the previous Time
Base indication.
9. Turn off the RECORD TRACK select key of the copy
(or move) source track.
• To restore the data that existed prior to the paste operation,
press the UNDO/REDO key.
• To restore the pasted data after you undo the paste
operation, press the UNDO/REDO key again.
Note:
The Undo/Redo function is effective only when the FD-8 is
stopped.
Note:
If you perform one of the following operations after you use
the Copy & Paste or Move and Paste operation, the Undo/Redo
function will no longer be effective.
1. When a new recording is made.
2. When a new editing is executed (such as Copy & Paste, Move &
Paste, Erase).
3. While in the AUTO PUNCH ON mode, when the AUTO PUNCH
IN point is passed in the PLAY (or RECORD) mode.
4. When the power is momentarily switched off.
5. When the program is changed.
6. When the disk is ejected.
Executing Paste
4. Press the EXECUTE/YES key again.
The display indication enables you to set the number of
the paste operations. The number and [SURE ?] flash.
At this time, the flashing RECORD TRACK select key LED
becomes continuously lit.
Flashing