Filter
Top Products
Locate Function
71
PLAY
AUTO
2
1
3
Executing the Auto Play function
1. Press the AUTO RTN/AUTO PLAY key to turn on
the [PLAY] indicator on the bottom of the display.
2. Press the desired memory key.
3. Press the LOCATE key.
The FD-8 locates the point and plays as shown in the
diagram.
Auto Return
This function allows the FD-8 to play data up to the AUTO RTN END point, then automatically locate the AUTO
RTN START point as shown in the diagram below.
To enable this function, AUTO RTN mode should be on and the AUTO RTN START point and AUTO RTN END point
should already be set.
• You can set a preroll time in the [Preroll ?] menu in SETUP
mode so that the FD-8 will start playback preroll time before
the locate point.
You can set the preroll time from 0 to 10 seconds. Refer to
the chapter “Changing the Initial Settings (SETUP Mode)”
on page 102.
<Operation of the Auto Return mode.>
Automatic locating to the AUTO RTN START point
subsequent to playback to the AUTO RTN END point.
AUTO RTN END point
AUTO RTN START point
STOP
PLAYBACK
LOCATE
PLAYBACK
START