Filter
Top Products
44
Punch In/Out Recording
TAKE
A. PUNCH
1. Press the RECORD TRACK select key [3/L] to set
track 3 to READY.
2. Locate a point slightly before the Auto Punch In
point.
3. Confirm that Auto Punch mode is turned on.
If it is not on, press the RECORD button while holding
down the SHIFT key.
4. Press the RECORD button while holding down the
PLAY button.
The flashing [RHSL] on the display changes to an
illuminated [TAKE], and recording starts.
The FD-8 operates as follows. To record, hold down the
PLAY button and press the RECORD button.
Auto Punch In/Out Take
After you are satisfied with your rehearsal, you can proceed to an actual take of Auto Punch In/Out.
You can undo or redo Auto Punch In/Out recording if you change your mind. The control panel settings are the
same as those for rehearsal.
5. When you finish recording, press the STOP button.
6. Play track 3 to check the result of the Auto Punch
In/Out operation.
Undo/Redo Auto Punch In/Out recording
You can undo or redo Auto Punch In/Out recording.
Press the UNDO/REDO key after recording is complete to restore the conditions that existed prior to the recording.
Press the UNDO/REDO key again to restore the conditions that existed after the recording. Follow the notes
below:
Track 5
Track 6
Track 7
Track 8
Auto Punch In point
(Take In)
Auto Punch Out point
(Take Out)
Track 1
Track 2
Track 3
Track 4
This part is changed.
Playback
start point
Playback
end point
The FD-8 punches in
automatically at the
Auto Punch In point.
The FD-8 punches out
automatically at the
Auto Punch Out point.
All tracks are in playback
monitoring mode.
All tracks are in playback
monitoring mode.
Only track 3 in input
monitoring, and data will be
recorded.
The RECORD LED lights up
un this area.
• The LED of the REC TRACK select key 3/L remains steadily
lit between the Punch In and Out points. Otherwise, it flashes.
• When the Auto Punch Out point is passed, the FD-8 cancels
Auto Punch mode automatically, and nothing appears in the
A. PUNCH display area.
<Caution after Punch Out>
At “Take” of punch out, the punch-in recording track will not
immediately enter the repro monitor mode from the input
monitor mode enter the repro monitor mode about two
seconds after mute playback. This is a functional feature of
FD-8 and not a malfunction.
Note-1: The Undo/Redo function is effective only when the FD-8 is stopped.
Note-2: The Undo/Redo is not effective if you perform one of the following operations after you finish recording:
• When a new recording is made.
• While a new editing is executed (such as Copy & Paste, Move & Paste, or Erase).
• When in the AUTO PUNCH ON mode, when the AUTO PUNCH IN point is passed in the PLAY (or RECORD) mode.
• When the power is momentarily switched off.
• When the program is changed.
• When the disk is ejected. (Removable disk only.)