Filter
Top Products
39
Recording to a Metronome Sound
1
2
3
4
5
6
7, 8, 9
10
11
12
Setting the switch and knob
1. Set channel 7 LEVEL switch to [L].
2. Set channel 7 INPUT SEL switch to [INPUT].
3. Set the SELECTOR in the monitor section to [MON].
4. Set the RECORD TRACK select key 2/R to READY.
5. Turn channel 7 PAN knob all the way to [R].
6. Raise the master fader L/R to [7-8].
Creating a Tempo Map
7. Set the time signature using the “Setting a time
signature” menu in SETUP mode.
Refer to the “Setting a time signature” section on page
98.
8. Set a tempo for a given point using the “Setting a
tempo” in SETUP mode.
Refer to the “Setting a tempo” section on page 100.
Turning the Metronome function on
9. Turn the Metronome function on using the “Setting
the Metronome function” menu in SETUP mode.
Refer to the “Setting the Metronome function” section
onpage 101.
Checking the metronome sound
10. Select the BAR/BEAT/CLK Time Base using the
TIME BASE SEL switch.
11. Start playback from the beginning of the Program.
Even if the selected Program does not have any recorded
data, track 8 outputs the metronome sound and the FD-
8 counts time.
12. Turn the MON knob of channel 8 MON mix section
toward TRK, and turn the MASTER knob in the
monitor section gradually.
You will hear the metronome output from track 8 using
the tempo and time signature set in the Tempo Map.
Compressor/Limiter