Filter
Top Products
36
Handling Programs
44.1kHz
SETUP
DRIVE
AUTO A.PUNCH
SYNC OUT
CLK
SCSI
1
2, 4
3, 5
4
4
SETUP
DRIVE
AUTO A.PUNCH
SYNC OUT
CLK
SCSI
44.1kHz
44.1kHz
SETUP
DRIVE
AUTO A.PUNCH
SYNC OUT
CLK
SCSI
PGM
Editing a Program title
You can name the Program as explained in the “Creating a new Program” section. You can also change the title
later by using the [Title Edit ?] menu in SETUP mode.
Note:
You can edit the title of the selected Program before you
select SETUP mode. You cannot select a Program after the FD-8
enters SETUP mode. Be sure to select the desired Program using
the steps explained in the “Using the Program Change function”
section.
1. Press the SETUP key while the FD-8 is stopped.
The FD-8 enters SETUP mode and displays the first
hier archy level of the SETUP menu that was selected
before you turned off the power.
2. Turn the JOG dial to select the first hierarchy level
of the [Title Edit ?] ([t] and [?] flash alternately.)
menu.
The currently-selected Program number also appears.
You can also use the HOLD/> key, the REWIND button, or
the F FWD button to select the first hierarchy level
display.
3. Press the EXECUTE/YES key.
The currently-selected Program title appears with the left-
most character flashing.
4. Press the HOLD/> key, the REWIND button, or the
F FWD button to move the flashing cursor, and use
the JOG dial to enter characters or numbers.
To move the flashing cursor, press the HOLD/> key, the
REWIND button, or the F FWD button. The F FWD button
is the most convenient.
You can enter up to 16 characters, nine of which will
appear on the display.
You may enter the following characters and numbers:
5. After you enter the title, press the EXECUTE/YES
key.
The new title is confirmed, and the ABS time value of the
Program appears.