Filter
Top Products
90
Connecting to Your Computer
Switching USB Drivers
The USB driver to be used when a computer is connected to the USB
connector is determined as follows:
1. Press the [MENU] button.
2. Press the Cursor [
] [ ] buttons to select “0.SYSTEM,” and
then press the [ENTER] button.
3. Press the Cursor [
] [ ] buttons to switch screens, and
press the Cursor [ ] [ ] buttons to move the cursor to
“USB Driver.”
4. Use the [DEC] [INC] buttons or the VALUE dial to select the
USB driver you want to use.
Parameter Value Description
USB Driver
ORIGINAL
Choose this if you want to use the USB
driver you downloaded from the Roland
website.
GENERIC
Choose this if you want to use the
standard USB driver that was included
with your computer.
5. Press the [LAYER EDIT] (WRITE) button.
6. Turn the power o, then on again.
Changing the USB Memory Setting
In some cases, when USB memory is connected to the USB MEMORY
connector, it may take longer for data to be loaded, or data may fail
to be loaded successfully. If this occurs, you may be able to solve the
problem by changing the USB memory setting.
1. Press the [MENU] button.
2. Press the Cursor [
] [ ] ] buttons to select “0.SYSTEM,” and
then press the [ENTER] button.
3. Press the Cursor [
] [ ] buttons to switch screens, and
press the Cursor [ ] [ ] buttons to move the cursor to
“USB Memory Mode.”
4. Use the [DEC] [INC] buttons or the VALUE dial to edit the
value.
Parameter Value
USB Memory Mode Mode1, Mode2
5. Press the [LAYER EDIT] (WRITE) button.
6. Turn the power o, then on again.
Using the RD-700NX as a USB MIDI
Interface
If the RD-700NX is connected to your computer, performance data
from a MIDI device connected to the RD-700NX’s MIDI IN connector
can be sent to your computer.
Parameter Value Description
USB MIDI Thru Sw
OFF
Performance data from the device
connected to the RD-700NX’s MIDI
IN connector will not be sent to your
computer.
ON
Performance data from the device
connected to the RD-700NX’s MIDI IN
connector will be sent to your computer.