Filter
Top Products
18
Top, Front, and Rear Panels
7
INT/EXT buttons
These buttons switch between Internal and External
modes. Normally you will leave Internal mode selected.
(p. 15)
FUNC button
You can hold down [FUNC] and press another button or
pad to access an alternate function for that button or pad.
CLIP BOARD button
This button lets you use the clip board to copy a sample.
(p. 32)
SAMPLING button
Use this button to perform sampling. (p. 26, p. 42)
PAD BANK button
Use this button to switch pad banks. (p. 23)
ROLL button
Use this button to play a roll. (p. 30)
HOLD pad
This pad activates the Hold function. (p. 30)
INPUT SOURCE pad
This pad sounds the audio input signal. (p. 25)
Pads [1]–[16]
You can play samples by striking these pads. (p. 23)
fig.front-panel
Memory card slot
You can insert a memory card here. (p. 22)
* You can use a Phillips screwdriver to remove the two screws
immediately under each end of the card slot (i.e., on the SP-
606’s bottom panel edge closest to yourself), and use these same
two screws to attach the included card theft prevention cover.
This will prevent the memory card from being removed and
stolen.
* When turning the unit upside-down, get a bunch of
newspapers or magazines, and place them under the four
corners or at both ends to prevent damage to the buttons and
controls. Also, you should try to orient the unit so no buttons
or controls get damaged.
* When turning the unit upside-down, handle with care to avoid
dropping it, or allowing it to fall or tip over.
Front Panel
SP-606_e.book 18 ページ ２００４年６月２１日 月曜日 午前１０時８分