Filter
Top Products
81
Chapter 12. System Settings
12.
The message “This will clear all the internal contents. Are you sure?” will appear. Press [F3] (EXEC).
If you decide to cancel, press [F2] (CANCEL).
The display will indicate “Executing...”
13.
The message “Please Power Off.” will blink. Turn off the power of the SP-606, and then turn it back on
again.
1.
Go to the Play screen (p. 15).
2.
Press [MENU] to get the Top Menu screen.
3.
Move the cursor to the “1:SYSTEM” line and press [ENTER].
The
SYSTEM
screen will appear.
You can access the
SYSTEM INFO
screen by holding down
[FUNC] and pressing [F1] (INFO). (p. 82)
4.
Press [F1] (CONFIG).
5.
Use [ ][ ] to select the parameter you want to set.
Turn the VALUE dial or use [DEC][INC] to set the value.
6.
Press [F2] (CTRL).
7.
Use [ ][ ] to select the parameter you want to set.
Turn the VALUE dial or use [DEC][INC] to set the value.
8.
Press [EXIT] to return to the Play screen.
Making System Settings
Parameter
Value Explanation
LCD Contrast
1–16 Adjusts the contrast of the display.
Sampling
Grade
STANDARD,
LONG
Specifies the sampling grade.
STANDARD
: Standard audio quality.
LONG
: Somewhat lower audio quality than STANDARD, but uses only
half the amount of memory.
Metro. Mode OFF, ON,
REC ONLY,
PLAY&REC
Specifies the metronome setting.
OFF
: The metronome will not sound.
ON
: The metronome will always sound.
REC ONLY
: The metronome will sound only while recording.
PLAY&REC
: The metronome will sound during playback and recording.
Metronome
Level
0–127 Specifies the metronome volume.
Preload Ptn WRITABLE,
PROTECT
Specifies whether the preloaded patterns (the patterns loaded in internal
memory when the SP-606 is shipped) are protected.
WRITABLE
: The preloaded patterns can be edited or erased.
PROTECT
: The preloaded patterns are protected; they cannot be edited or
erased.
Parameter
Value Explanation
Foot Sw
Assign
OFF,
START/STOP,
TAP TEMPO,
MFX1 SW,
MFX2 SW
Specifies the function of the foot switch.
OFF
: Not used.
START/STOP
: Song or pattern playback will start/stop each time you
press the foot switch.
TAP TEMPO
: The tempo will be set by the interval at which you press the
foot switch (Tap Tempo function -> p. 25, p. 66).
MFX1 SW
: MFX1 will turn on/off each time you press the foot switch.
MFX2 SW
: MFX2 will turn on/off each time you press the foot switch.
D Beam Sens 0–127 Adjusts the sensitivity of the D Beam controller.
SP-606_e.book 81 ページ ２００４年６月２１日 月曜日 午前１０時８分