Filter
Top Products
76
Chapter 10. About V-LINK
1.
Use [ ][ ] to choose the setting (parameter) you want to edit.
2.
Turn the VALUE dial or use [DEC][INC] to edit the value of the parameter.
3.
When you have finished setting the parameters, press [F3] (WRITE) to store the settings.
A message of “System Write, Are You Sure?” will appear. Press [F3] (EXEC) if you want to store the settings, or
press [F2] (CANCEL) if you decide to cancel.
V-LINK Setup Parameters
Parameter Value Explanation
V-LINK Ctrl Ch 1–16 Specifies the MIDI channel used to control V-LINK functions.
CTRL1
CTRL2
CTRL3
D Beam
OFF,
PLAY SPEED,
DISSOLVE TM,
T BAR,
COLOR Cb,
COLOR Cr,
BRIGHTNESS,
VFX1,
VFX2,
VFX3,
VFX4,
OUT FADER
Assign V-LINK functions to the control knobs and D Beam controller.
OFF
: No V-LINK function is assigned.
PLAY SPEED
: Playback speed
DISSOLVE TM
: Dissolve time (the time over which images will
change)
T BAR
: T bar
COLOR Cb
: Color Cb (color difference signal)
COLOR Cr
: Color Cr (color difference signal)
BRIGHTNESS
: Brightness
VFX1
: Visual effect 1
VFX2
: Visual effect 2
VFX3
: Visual effect 3
VFX4
: Visual effect 4
OUT FADER
: Output fader
Seq Ctrl Bank OFF, 1–32 Of the pad settings included in the pattern data, only the pads of the
specified pad bank will be assigned to V-LINK functions.
Appendix
Controllable V-LINK Functions and MIDI Messages
V-LINK function
Transmitted MIDI message Controller
Clip/Photo 1–16
PC Pad
Palette/Page 1–32 CC#0 (Bank Select)
Playback Speed CC#8 (Balance) CTRL1
CTRL2
CTRL3
D Beam
Dissolve Time CC#73 (Attack)
T Bar CC#11 (Expression)
Color Cb CC#1 (Modulation)
Color Cr CC#71 (Resonace)
Brightness CC#74 (Cutoff)
VFX1 CC#72 (Release)
VFX2 CC#91 (Reverb)
VFX3 CC#92 (Tremolo)
VFX4 CC#93 (Chorus)
Output Fade CC#10 (Panpot)
SP-606_e.book 76 ページ ２００４年６月２１日 月曜日 午前１０時８分