Filter
Top Products
21
Turning the Power On/Off
Once the connections have been completed (p. 20), turn on power to your various devices in the
order specified. By turning on devices in the wrong order, you risk causing malfunction and/or
damage to speakers and other devices.
1.
Turn the VOLUME knob all the way to the left to set the volume to the minimum position.
2.
Turn the volume of the connected amp or audio system to the minimum position.
3.
Press [POWER] to power up the SP-606.
This unit is equipped with a protection circuit. A brief interval (a few seconds) after power up is
required before the unit will operate normally.
4.
Power up the connected amp or audio system.
5.
While striking a pad to produce sound, adjust the volume by gradually raising the VOLUME knob.
Also raise the volume level of the connected amp or audio system to the appropriate level.
Before powering off the SP-606, you must first perform the shutdown operation. If you simply turn
off the power without shutting down, the data in internal memory or the memory card may be
damaged.
1.
Go to the Play screen (p. 15).
2.
Hold down [FUNC] and press [EXIT] (SHUTDOWN) to get the SHUTDOWN screen.
3.
Press [F3] to shut down.
When you have returned to the Play screen, it is safe to switch off the power.
If you decide not to shut down, press [F2] (CANCEL).
4.
Lower the volume on the SP-606 and all your external equipment so they’re at the lowest possible level.
5.
Switch off all your external equipment.
6.
Press [POWER] to switch off the SP-606’s power.
Turning the Power On
Shutting Down and Turning the Power Off
SP-606_e.book 21 ページ ２００４年６月２１日 月曜日 午前１０時８分