Filter
Top Products
70
Chapter 8. Using a Memory Card
This operation saves backup data (all settings of the SP-606, including the samples, pad banks, patterns, and
songs) to a memory card. Up to four sets of backup data can be saved on one memory card.
Fewer sets of backup data can be saved if numerous samples have been saved on the card, reducing
its remaining free capacity.
1.
In the CARD UTILITY screen, use [ ][ ] to move the cursor to the
“Backup Save” line.
2.
Press [ENTER] to get the BACKUP SAVE screen.
Empty backup data sets are displayed as dotted lines.
You can also get to the same screen by pressing [F1] (SAVE)
from the
CARD UTILITY
screen.
If a memory card is not inserted, the message “Card Not Ready!” will appear.
3.
Turn the VALUE dial or use [ ][ ][ ][ ][DEC][INC] to select 1–4 as the “Backup” setting.
This selects the backup set in which the data is to be saved.
4.
Press [F3] (EXEC) to save the backup data.
If you decide to cancel, press [F2] (CANCEL).
If the save destination you selected already contains backup data, the message “A Backup Data
Already Exists! Overwrite?” will appear. If you want to overwrite the existing data, press [F3]
(EXEC) or [ENTER]. If you decide to cancel, press [F2] (CANCEL) or [EXIT].
This operation loads backup data (all settings of the SP-606, including the samples, pad banks, patterns, and
songs) from a memory card.
Be aware that when you execute the Backup Load operation, the internal settings will be replaced
(overwritten) by the backup data that is loaded.
1.
In the CARD UTILITY screen, use [ ][ ] to move the cursor to the
“Backup Load” line.
2.
Press [ENTER] to get the BACKUP LOAD screen.
Empty backup data sets are displayed as dotted lines.
You can also get to the same screen by pressing [F2] (LOAD)
from the
CARD UTILITY
screen.
If a memory card is not inserted, the message “Card Not Ready!” will appear.
3.
Turn the VALUE dial or use [ ][ ][ ][ ][DEC][INC] to select 1–4 as the “Backup” setting.
This selects the backup set from which the data will be loaded.
4.
Press [F3] (EXEC) to load the backup data.
If you decide to cancel, press [F2] (CANCEL).
BACKUP SAVE
BACKUP LOAD
SP-606_e.book 70 ページ ２００４年６月２１日 月曜日 午前１０時８分