Filter
Top Products
69
Detailed Settings for Each Function (EDIT)
EDIT
Changing the Tone Wheel Brake
Message
TWBrk Ctrl Msg (1–8)
This determines the number of the message to be used for
transmitting and receiving the status of the wheel brake
effect produced using the control pedal.
You can set any general-purpose controller 1–8.
Changing the Pedal Wah Message
PedalWahCtrlMsg (1–8)
This determines the number of the message to be used for
transmitting and receiving the status of the pedal wah effect
produced using the control pedal.
You can set any general-purpose controller 1–8.
Switching Synth MFX Control Messages
SynthMFXCtrlMsg (1–8)
This determines the message number when transmitting or
receiving the status of the synth part’s MFX CONTROL
knob. You can set any general-purpose controller 1–8.
Switching Harmonic Bar Messages
MIDI Snd Ctrl (ON/OFF)
This setting determines whether or not the harmonic bar
information is received using the MIDI message sound
controller. When set to On, the MIDI message sound
controller is used in receiving the harmonic bar information;
when set to Off, the sound controller is disregarded.
Settings of REGISTRATION
(REGISTRATION COMMON)
Renaming a REGISTRATION
Regist Name
You can rename a REGISTRATION. You can use up to
twelve characters in naming registrations.
1. Select the registration you wish to rename.
2. Hold down the [EDIT] button, and press the
REGISTRATION [3] (REGIST COMMON)
button.
The Edit’s “REGIST COMMON” screen is displayed.
3. Press CURSOR [ ] button to display the
following screen.
fig.06-09(RenameFile)
4. Press the [ENTER] button.
A screen like the one shown below appears.
fig.06-10(SelectRenFile)
The cursor appears at the Registration name to the lower
left of the display.
5. Rename Registration.
Available characters/symbols:
Space, A–Z, a–z, 0–9, ! “ # $ % & ‘ ( ) * +, - . / ; : < = > ? @
[
¥ ] ^ _ ` { | }
Move the cursor by using the CURSOR [ ][ ]
buttons to the location where you wish to change a
character.
Change a character with the CURSOR [INC] [DEC]
buttons.
When the [ ] button is pressed, a single-character
blank space is inserted; pressing the [ ] button deletes
one character.
If you cancel a Renaming Registration function, press the
[EXIT] button to return to step 3.
6. Press the [ENTER] button to set the name.