Filter
Top Products
77
Detailed Settings for Each Function (EDIT)
EDIT
Bulk Dump Temp
Transmit the contents of the selected Registration.
1. Hold down the [EDIT] button, and press the
REGISTRATION [7] (UTILITY) button.
The Edit’s “UTILITY” screen is displayed.
2. Press CURSOR [ ] button to display the
following screen.
fig.06-04(BulkDumpTemp)
Pressing the [EXIT] button, return to the basic screen.
3. Start recording on your sequencer.
4. Press the [ENTER] button to begin saving the
settings.
While the settings are being saved, sending message is
displayed.
When the save has been completed,
a message
indicating that it is completed appears in the
display, and return to the basic screen.
5. Stop recording on your sequencer.
Bulk Dump All
This send all settings.
1. Hold down the [EDIT] button, and press the
REGISTRATION [7] (UTILITY) button.
The Edit’s “UTILITY” screen is displayed.
2. Press CURSOR [ ] button to display the
following screen.
fig.06-05(BulkDumpAll)
Pressing the [EXIT] button, return to the basic screen.
3. Start recording on your sequencer.
4. Press the [ENTER] button.
A screen like the one shown below appears, and saving
the settings is beginning.
fig.06-06(Sending)
After a short while, when transmission is finished, a
message indicating that it is completed appears and
the basic screen returns to the display.
5. Stop recording on your sequencer.
6. If you press [EXIT] button while transmission is
still in progress, the following message appears,
and the basic screen returns to the display.
fig.06-07(Aborted!)