Filter
Top Products
78
Detailed Settings for Each Function (EDIT)
Loading Back Data That’s Been Saved
on an External Sequencer
1. Make sure that the power of the VR-760 and your
sequencer is off.
Turn off the power of the VR-760 and the other device before
making connections. If you connect an external device when
the power is turned on, damage or malfunctions may occur.
2. Connect the VR-760’s MIDI IN connector to the
sequencer’s MIDI OUT connector
3. Turn on the power of the external sequencer and
the VR-760.
4. Play back your sequencer.
The settings saved to the sequencer are loaded by the
VR-760.
5. When the external sequencer has finished playing
back, the message is displayed.
A screen like the one shown then below appears, the VR-
760 writes the data to the internal memory.
fig.06-08(DataWriting)
When writing has finished, a message indicating that
it is completed appears in the display, and the basic
screen will appear.
Be sure never to turn off the power while this data is being
written (while following display is showing), damage or
malfunctions may occur.
■ Using a Memory Card
Format Card
This function initializes (formats) a memory card so that VR-
760 data can be saved to it. Before a new memory card or a
memory card used on another device can be used on the VR-
760, it must be formatted on the VR-760. For more details,
refer to (p. 57).
Save File
With the VR-760, you can take all of the content in the
registration and the system settings and save them as a single
file to a memory card. For more details, refer to (p. 58).
Load File
This function load a File from Memory Card into the VR-760.
For more details, refer to (p. 59).
Rename File
This function rename file saved to the memory card.
For more details, refer to (p. 59).
Delete File
This function delete file saved to the memory card.
For more details, refer to (p. 60).
■ Factory Reset
The settings stored in the VR-760 can be returned to their
factory settings.
For more detailed instructions, refer to (p. 20).