Filter
Top Products
Parameter Settings
TENORI-ON Manual 23
Setting Parameters with the Function Buttons Solo Mode
Settings can be made by holding one of the ten function buttons located on either side of the
TENORI-ON ([L1] — [L5], [R1] — [R5]) and operating the LED buttons.
When a function button is pressed the current setting for that button will appear on the LED
button matrix, and the setting can be changed by pressing the appropriate LED button(s).
Settings available via the function buttons also appear on the LCD display during
adjustment. At this time you can also use the jog dial for finer adjustment.
The settings available via the function buttons are as follows:
Setting Parameters with the Function Buttons
Button Function Description Page
[L1] Instrument Selects the voice for the current layer. 24
[L2] Sound Length Sets the gate time (note length) for all active notes in the current layer. 25
[L3] Octave Sets the octave for all active notes in the current layer. 26
[L4]
Loop Point (Score
Mode)
Sets the loop range when a Score Mode layer is selected. 27
Rotation (Random
Mode)
Sets the direction and speed of rotation for active note shapes in the Random
Mode.
28
[L5] Loop Speed
Sets the beat length (the speed of the loop indicator) for Score Mode layers
only.
29
[R1] Layer No. Switches layers. 30
[R2] Master Tempo Sets the tempo for all layers and blocks. 31
[R3] Master Transpose Sets transposition for all layers and blocks. 32
[R4] Volume Sets the volume for each layer (common to all blocks). 33
[R5] Block No. Switches blocks. Also used for layer and block copy. 34
ÅÍÎÏ ∞
≈01-Score Ω01
ç01/01:SoftBeep
√00:00:00 ≥
[L1]
[L2]
[L3]
[L4]
[L5]
[R1]
[R2]
[R3]
[R4]
[R5]
Function Buttons Function Buttons
LED Buttons
LCD Display
Jog Dial