Filter
Top Products
Parameter Settings
TENORI-ON Manual 81
Setting Parameters with the Jog Dial ■ File Menu
4 Current Layer files on the card will appear as a list on the LCD display (with no file
extension). Use the jog dial to select the file you want to rename.
● Only files that are in Current Layer format will be displayed.
Press the [OK] button to go to the file name entry display. The name of the currently
selected Current Layer file will be displayed, and you can enter a new file name as
required. File name entry procedure is described in the Rename Song section on
Page 65.
● File names can be up to 16 characters in length. The file extension will be added automatically.
5 When the file name has been entered as required use the jog dial to highlight the "
§
"
symbol in the lower right corner of the display and press the [OK] button.
"Executing …" will appear on the display while the file is being renamed.
File data may be irreparably corrupted if you turn off the power or remove the SD Memory Card while the
"Executing…" display is showing.
●
If a file with the same name exists on the SD Memory Card an overwrite confirmation display like the
one shown below will appear.
● Press the [OK] button if it’s OK to overwrite the file. Press the [CANCEL] button (or use the jog dial to
select "CANCEL" on the LCD and then press the [OK] button) to cancel the operation and leave the
original file unaltered.
6 The display shown in step 3, above, will reappear when the operation has finished.
Layer[01]: Rename ∞
0302E-LAYER-01
0302E-LAYER-02
0302G-LAYER-01
Input File Name ∞
[0302E-LAYER-02 ]
ABCDEFGHIJKLMNOPQRST
UVWXYZ-0123456789 ª§
Current Layer File Name
Available Characters
Input Cursor
Set File Name
Backspace & Delete 1 Character
Layer[01]: ∞
"1-LAYER1001-01 "
Already Exists!
Overwrite? OK