Filter
Top Products
Parameter Settings
TENORI-ON Manual 28
Setting Parameters with the Function Buttons [L4] Random Mode Rotation
[L4] Random Mode Rotation
When a Random Mode layer is selected you can spin loop-shapes by holding the [L4] button
and running a finger around the matrix in the direction and at the speed of the desired spin.
● Rotation direction and speed settings apply to the same layer in all blocks.
● To stop rotation, press and hold the LED button, or press the same LED button twice while holding the [L4]
button. Pressing the [CLEAR] button clears only the active notes, leaving the rotation data active unless
rotation has been stopped.
● Individual notes cannot be entered or cleared by pressing their LED buttons during rotation.
■ Range . . . . . . . . . . . .The speed at which the LED buttons are stroked is detected, and the nearest rotation
speed* is automatically selected from the eight listed below.
4 beats (384 clocks),
3 beats (288 clocks),
2 beats (182 clocks),
1 beat (96 clocks),
3/4 beat (72 clocks),
1/2 beat (48 clocks),
1/4 beat (24 clocks),
1/8 beat (12 clocks)
* Rotation speed: Each complete rotation consists of 32 steps, and thus each step covers
an angle of 11.25°. Rotation speed is specified as the number of beats between steps.
[Reference]
❊
The length of each beat can be adjusted via the Loop Speed parameter (Loop Speed ➝ Page 29, 51. Master
Loop Speed ➝ Page 45).
■ Default . . . . . . . . . . . none
[Reference]
❊
Random Mode (➝ Page 17)
Rotation ∞
Layer[08] [Random]
Current Layer Number