Filter
Top Products
Parameter Settings
TENORI-ON Manual 26
Setting Parameters with the Function Buttons [L3] Octave
[L3] Octave
Sets the octave for all active notes in the current layer.
While holding the [L3] button slide your finger vertically over the matrix to move the lit
horizontal line to the desired octave, or simply press an LED button in the appropriate row.
The eighth row from the bottom produces no octave shift (a "0" setting). Each row above that
shifts the pitch up by the corresponding number of octaves up to "+5", while each row below
that lowers the pitch by the corresponding number of octaves down to "-5". Pressing an LED
button outside the maximum octave shift range of -5 — +5 has no effect.
● Changes will not be applied to notes that are already playing in the Push or Solo modes, or currently playing
notes if a long Sound length has been specified.
■ Range . . . . . . . . . . . .-5 — +5 octaves
■ Default . . . . . . . . . . . 0 (all layers)