Filter
Top Products
Parameter Settings
TENORI-ON Manual 39
Setting Parameters with the Jog Dial Data Storage and Initialization
Data Storage and Initialization
Data that is Erased When the Power is Turned Off
■ All block set
All active notes and settings for all layers and blocks are not retained in memory when the
power is turned off, so if you want to keep any active notes data you have created you will
need to use the Save All Blocks function described on Page 69 to save it to an SD Memory
Card.
■ Data Listed as "Save as Default" in the "Backup" Column of the Chart Below
These items are not retained in memory when the power is turned off, but can be saved to
the internal flash ROM as the default settings by using the Save As Default function
described on Page 106. Settings saved in this way become the power-on default settings.
Items listed as "Automatic Backup" in the "Backup" column of the chart are automatically
saved as the power-on default settings whenever a change is made.
Initialization
The entire system can be restored to the factory default settings by using the Factory Reset
function described on Page 108. To reset all active notes and settings for all layers and
blocks, use the Reset All Blocks function described on Page 58.
All data will be erased when the Factory Reset function is executed. Be sure to save any data you want
to keep to an SD Memory Card beforehand.
All layer and block data will be erased when the Reset All Blocks function is executed. Be sure to save
any data you want to keep to an SD Memory Card beforehand.
Menu Settings
Parameter Backup Factory Default
Play Menu Hardware Volume Automatic Backup 96
Master Tempo
Save As Default
75
Master Scale lonian
Master Transpose 0
Master Loop Speed
Cannot be backed up.
But since this setting is
related to the Layer menu
Loop Speed parameter, it
can be saved as the default
layer setting by using the
Save As Default function.
4
Master Loop Point
TOP Cannot be backed up.
But since this setting is
related to the Loop Point
settings accessed via the
function buttons, it can be
saved as the default layer
setting by using the Save As
Default function.
1
END 16
Reset Loop Timing Cannot be backed up. OK
Mute Save As Default OFF