Filter
Top Products
Parameter Settings
TENORI-ON Manual 33
Setting Parameters with the Function Buttons [R4] Volume
[R4] Volume
Layer Volume
Allows the volume of each layer to be adjusted as required (layer volume common to all
blocks).
When the [R4] button is pressed the current volume settings for all 16 layers are displayed
on the LED button matrix. Each row of LED buttons corresponds to layer, beginning with
layer 01 at the bottom row.
While holding the [R4] button slide your finger horizontally over the row corresponding to the
layer you want to adjust to set the volume as required. Moving a setting to the right increases
the volume of the corresponding layer.
Master Volume
You can also use the jog dial while holding the [R4] button to set the master volume level (all
layers). The master volume value appears on the LCD display only.
■ Range . . . . . . . . . . . .Layer volume: 0 — 127
Master volume: 0 — 127
■ Default . . . . . . . . . . . Layer volume: 96 (all layers)
Master volume: 96
● To adjusts the instrument's basic volume level, refer to Hardware Volume (➝ Page 43).
[Reference]
❊
Layer menu/Volume (➝ Page 50)
The volume value set via the LED buttons.