Filter
Top Products
Parameter Settings
TENORI-ON Manual 80
Setting Parameters with the Jog Dial ■ File Menu
5 When the file name has been entered as required use the jog dial to highlight the "
§
"
symbol in the lower right corner of the display and press the [OK] button.
The file name will be entered and the save function will be executed.
A display like the one shown below will appear while the Current Layer file is being
saved.
You can cancel the operation by pressing the [OK] or [CANCEL] button.
File data may be irreparably corrupted if you turn off the power or remove the SD Memory Card while the
"Saving…" display is showing.
●
If a file with the same name exists on the SD Memory Card an overwrite confirmation display like the
one shown below will appear.
● Press the [OK] button if it’s OK to overwrite the file. Press the [CANCEL] button (or use the jog dial to
select "CANCEL" on the LCD and then press the [OK] button) to cancel the operation and leave the
original file unaltered.
6 The display shown in step 3, above, will reappear when the operation has finished.
● Rename Current Layer
Allows a new name to be entered for a Current Layer file on an SD Memory Card.
1 Insert the SD Memory Card containing the file you want to rename into the TENORI-ON
card slot.
2 Use the jog dial and [OK] button to navigate to the Current Layer function menu as
follows:
"Main menu" ➝ "File menu" ➝ "Current Layer"
3 Use the jog dial to highlight the "Rename" function, then press the [OK] button.
Layer[01]: ∞
"1-LAYER1020-01 "
Saving... CANCEL
The Current Layer file being saved.
Layer[01]: ∞
"1-LAYER1020-01 "
Already Exists!
Overwrite? OK
Layer[01]: ∞
Operation: Load
Layer[01]: ∞
Operation: Rename