Filter
Top Products
E-98
Connecting to an External Device
Printing Color Difference Target
M
emo
To print color difference target data, make sure that the instrument is connected to the printer with a printer cable.
Note
• The instrument and printer must be connected using a printer cable that is wired as shown in “Printer Cable
Wiring Diagram” (page E-92).
• Before connecting, make sure that the power to both the instrument and printer is turned OFF.
[Procedure]
This operation must be started from the <TARGET> screen.
1. Turn B to select “D”, then press A.
“D” will change to “E”.
2. Turn B to select the color difference target data to be printed, then press A.
“E” will return to “D”.
• Keeping B held down to left or right will cause the color difference target data No. (T
*
) to change
continuously.
3. Turn B to select “ ”, then press A.
M
emo
• If “SPECT.GRAPH” has been selected as the display mode, spectral reflectance data will be printed.
• If a mode other than “SPECT.GRAPH” has been selected as the diaplay mode, only colorimetric value data
will be printed.