Filter
Top Products
E-84
Pass/Fail Judgment for Color Difference
4
Turn B to select “TOLERANCE”, then press A.
The currently set tolerances will be
displayed.
5
If they are satisfactory, turn B to select “BREAK”, then press A.
The measurement screen will ap-
pear.
6
Place the specimen measuring port to the specimen, and then press C (MEAS.
button).
If “PASS/FAIL” has been selected
as the display mode, a judgment will
be made to check whether the meas
-
urement result is within the specified
ellipse, and “PASS” or “FAIL” will
be displayed accordingly.
• Example when the result is “PASS”.
• Example when the result is “FAIL”.
M
emo
• If “PASS/FAIL” has been selected as the display mode, “PASS” will be displayed only when the color difference
between the measured value and the target color is within each specified elliptical tolerance (up to four tolerances).
• If “DIFF/ABS” has been selected as the display mode, the measured results will not be highlighted even if they
are “FAIL”.
• If a color difference has not been set, when the target mode is “linked to each data.”, and the target color data
number set at the time of measurement is deleted, “----” appears instead of “PASS/FAIL”.
• If does not appear due to the auto power save function, this may be due the fact that it can take time to
start measurement after C is pressed.