Filter
Top Products
Using the JM-5’s MIDI functions
64
r
VIMA JM-5
Setting MIDI channels and other MIDI parameters
for the ‘Edit Tone Parts’ environment
1.
Use [MENU] button ‰ “MIDI” ‰ “Edit Tone
Parts” to go to the following display page:
2.
Use the [CURSOR÷VALUE] dial to select and
set the following parameters:
■ ‘Rx Event’ options:
3.
Press and hold the [EXIT] button (its indica-
tor stops flashing) to return to the JM-5’s
main page.
Parameter Setting Explanation
Part Tone1~3 Selects the part whose
settings you can
change.
Rx Off, On This parameter allows
you to specify whether
(On) or not (Off) the
selected part should
receive (RX) MIDI data.
Rx Ch 1~16 Allows you to assign a
MIDI channel to the
selected part.
Rx Shift -48~+48 This parameter allows
you to transpose the
received note mes-
sages before sending
them to the JM-5’s
tone generator. The
maximum possible
transposition is four
octaves up (+48) or
down (–48). Each step
represents a semi-
tone.
Rx Limit Low C–1~G9 These two parameters
allow you to set the
note range to be
received. If not all note
messages received on a
given MIDI channel
should be played by
the selected External
Tone Part, narrow
down the range.
Note: “Rx Limit Low”
cannot be higher than
“Rx Limit High” (and
vice versa).
Rx Limit High C–1~G9
Rx Event ‰ see below The RX section pro-
vides a number of fil-
ters that allow you to
specify whether the
messages in question
should be received (On)
or not (Off).
Rx Event Setting Meaning
Program
Change
Off, On Program change and
bank select (CC00,
CC32) messages. These
messages are used to
select sounds and
Drum Sets.
“Bank Select” messages
are control change
messages (CC) that
allow you to select
sound banks (up to
128).
Pitch Bender Off, On Pitch Bend messages.
Modulation Off, On Modulation messages
(CC01).
Volume Off, On Volume messages
(CC07).
Panpot Off, On Pan(pot) messages
(CC10).
Expression Off, On Expression messages
(CC11).
Reverb Off, On Reverb Send messages
(CC91).
Chorus Off, On Chorus Send messages
(CC93).
Hold Off, On Hold (Sustain, Damper)
messages (CC64).
Sostenuto Off, On Sostenuto messages
(CC66).
Soft Off, On Soft messages (CC67).
Caf Off, On Channel aftertouch.
RPN Off, On Registered parameter
number (CC100/101).
NRPN Off, On Non-registered param-
eter number (CC98/99).
System
Exclusive
Off, On SysEx messages (sys-
tem exclusive).
Select All — Switches all event fil-
ters off or on.
JM-5_US.book Page 64 Tuesday, December 14, 2010 10:29 AM