Filter
Top Products
19
Getting Ready
941
Once the connections have been completed, turn on power to your various devices in the order
specified. By turning on devices in the wrong order, you risk causing malfunction and/or
damage to speakers and other devices.
1.
Before you turn on the power, use the VOLUME slider to minimize the volume.
Also completely turn down the volume of any connected audio device and other equipment.
fig.00-09
2.
Press the [POWER] switch on the back of the RD-300GX to turn on the power.
The unit is powered up, and the display’s backlighting comes on.
fig.00-10
To prevent incorrect functioning of the Pitch Bend/Modulation Lever (p. 34), refrain from
touching the lever while the power to the RD-300GX is turned on.
This unit is equipped with a protection circuit. A brief interval (a few seconds) after power up is
required before the unit will operate normally.
In the unlikely event the power is turned off or cut off while Factory Reset (p. 77) is in progress,
the data may become corrupted, and it may require additional time for the unit to start up the
next time.
3.
Turn on the power to connected external devices.
4.
Adjust the volume of the connected external devices.
5.
Adjust the RD-300GX’s volume to obtain the proper volume level.
Turning the Power On and Off
Turning On the Power
NOTE
On
Lower
Position
NOTE
NOTE
NOTE
RD-300GX_e.book 19 ページ ２００８年２月１４日 木曜日 午後１時２６分